Injection Moulding Co., Ltd
1Products, 3News, 0Sell Leads
Home
About Us
Products
News
Sell Leads
Contact Us
About Us
Being a startup I am looking to manufacture my own injection moulds and press my own parts for my company, so I would say I am looking for each injection mould to support 25 to 250 pieces, aluminum will be much easier to work with on the CNC equipment I am looking to purchase for my company. I was concerned that aluminum might be not be strong enough if the required tonnage was too high but it sounds like it would work.
PAI (Torlon) is a material that is most suited for extreme conditions of temperature (for a polymer), aggressive chemicals, and wear--not items faced by the average humanoid. Do you have a list of properties needed or conditions that must be withstood by this humanoid? I ... more
Main Products
Injection Moulding
News
China Injection Mold Making Company
If there is Chinese plastic mold injection pressure or hold time the molecules will not be constrained, which allows them to move around uncontrolled during the mold cooling process. This causes the part to cool at different rates and results in injection mold warpage. Tips to possible solution on s ... more
2017/10/9
Injection Mould Cost Calculation
The mold valuation cannot be the direct quotation immediately. In general, it should also according to market conditions, customer psychology, competitors, state and other factors to comprehensive analysis the appropriate valuation, and then increase 10%-30% for the first offer. After bargaining, th ... more
2017/10/9
All Categories