This site uses cookies to provide you with a better experience. For information on our Privacy and Cookie Policy, please visit this page. By continuing to use the site or closing this banner, you are agreeing to our terms of use. Close

Injection Mould Cost Calculation

2017/10/09
  • LINE
  • X
  • LinkedIn

The mold valuation cannot be the direct quotation immediately. In general, it should also according to market conditions, customer psychology, competitors, state and other factors to comprehensive analysis the appropriate valuation, and then increase 10%-30% for the first offer. After bargaining, the price can be reduced according to the actual situation. However, when the offer to discuss the injection mould less than 10% of the valuation, the mould to be re-refined to improve estimates, to ensure the security of this favorable situation, the signing of the contract for mould processing, finalize the injection mould prices. Mould prices are approved and signed by both parties in the contract price.

In this case, the mold price may be higher or lower than the estimate. When the price is lower than the guaranteed, the injection mould needs to be re-amending the requirements, conditions, and other programs to reduce some of the requirements, in order to reduce the cost. After re-estimating, a contract price can be signed. It should be noted that the mould is high-tech specialty products, should not use low-cost, or even at a loss to cater to customers. But, it should be done at competitive prices, the quality assurance, precision, life in the first place, rather than the price. The pursuit of low-cost mould, it is difficult to ensure the injection mould quality, accuracy and service life. However, when the injection mould manufacturer is the same or has an economic interest in the relationship, in this case, the offer should be cost price quote. Die valuation estimate only the basic cost of the mould, the other costs and profits will not consider being products of the future profits. But this time the offer is not as true mould of the price, can only be used as a mold pre-development costs. In the future, once the products successfully developed, generate profits, should die for extracting value, the unit returned to the mould manufacturing, the two together to form a mould price. In this case the price of the mould is formed, there is likely to be higher than the price of a first mould case, even a high rate of return, is several times the original price of a normal injection mould, a few hundred dollars. Of course, there may be the rate of return equal to zero. Reading full article on http://www.injectionmoulding.org/injection-mould-cost-calculation-quotation.html

Recommendations For You

Browse Alphabetically : 0-9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z  Hot Searches
History
    Inquiry Cart